Outside Back Exhaust; Preparation Of Top Cabinet; Adapting Blower For Outside Back Exhaust - GE AVM4160 Installation Instructions Manual

ATTACH THE MOUNTING PLATE
C2
TO THE WALL cont
Spacing for Toggles More
Than Wall Thickness
Toggle Wings
Mounting
Toggle
Plate
Bolt
Wall
3
Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall to mount
the plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch
the bottom of the cabinet when pushed flush against
the wall and that the plate is properly centered under
the cabinet.
CAUTION:
the wall.
Tighten all bolts. Pull the plate away from the wall
4
to help tighten the bolts.
USE TOP CABINET TEMPLATE
C3
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
Read the instructions on the TOP CABINET
TEMPLATE.
Tape it underneath the top cabinet.
Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION:
Installation Instructions
Bolt
End
22
C4 ADAPTING BLOWER FOR

OUTSIDE BACK EXHAUST

1 Remove the blower motor screws that holds the blower
plate to the microwave oven. Slide the plate toward the
back of the microwave and lift up to remove.
Blower Motor Screws
Remove screw on the back of the unit.
2
3
Carefully remove fan from cavity. Remove the wire
from the notch at the bottom of the fan after it is
removed from the cavity.
The fan needs to be turned 180 degrees to the right
4
to be in the correct orientation, keeping the blower
part of the fan where the air comes out at the top
of the fan. The wire needs to be reinsterted into the
cage housing once it has been oriented correctly.
Wires
5 Remove the knockout plates in the back of the unit
with snips.
Back of mircrowave
Blower Plate
Screw
Fan Blades
Back of Microwave
Knockout Plates:
Snip all 4 webs on
each knockout panel
and remove the metal
knockouts for rear airflow.
Please take care to
remove any sharp edges
created from removing
the knockout plates.