Safety Camera Pois; Disclaimer; Compliance - Mio Moov User Manual

Safety Camera POIs

Mio products are designed to be used as an aid to safer driving. You can receive messages to alert you to
locations of safety cameras, which will enable you to monitor your speed through these areas. Mio does not
warrant that all types and locations of safety camera data are available, as cameras may be removed, relocated
or new cameras installed. Mio does not condone speeding or any other failure to comply with your local traffic
laws. It is your responsibility to drive within the posted speed limit at all times and to drive in a careful manner.
Mio accepts NO liability whatsoever for you receiving any speeding fines or points on your license through
using this device. Mio does not guarantee the accuracy of the data contained within this database either
expressed or implied. In the event you receive a fine or any other penalty for speeding or contravention of any
traffic law, or are involved in an accident, Mio is not responsible for any damages of any type. In some countries
the data information regarding safety or speed cameras may conflict with local law and/or regulations. It is
your responsibility to make sure that your use of the data is in compliance with local laws and/or regulations.
Usage is at your own risk.

Disclaimer

Due to continued product development this information may change without notice. Mio does not warrant that
this document is error-free. The screenshots and other presentations shown in this manual may differ from the
actual screens and presentations generated by the actual product.
All such differences are minor and the actual product will deliver the described functionality as presented in this
User Manual in all material respects.

Compliance

Note: For regulatory identification purposes, Moov 100/200-Series is assigned a model number of N206, Moov 300-Series is
assigned a model name of N207 and Moov 500-Series is assigned a model number of N210.
Products with the CE marking comply with Radio & Telecommunication Terminal Equipment Directive (R&TTE)
(1999/5/EC), the Electromagnetic Compatibility Directive (2004/108/EC) and the Low Voltage Directive
(2006/95/EC) - issued by the Commission of the European Community.
Compliance with these directives implies conformity to the following European Standards:
EN 300 328 (For models with Bluetooth capabilities only): Electromagnetic compatibility and Radio
spectrum Matters (ERM); Wideband Transmission systems; Data transmission equipment operating in the 2,4
GHz ISM band and using spread spectrum modulation techniques; Harmonized EN covering essential
requirements under article 3.2 of the R&TTE Directive
EN 301 357 (For models with FM transmitter capabilities only): Electromagnetic compatibility and Radio
spectrum Matters (ERM); Cordless audio devices in the range 25 MHz to 2000 MHz; Consumer radio
microphones and in-ear monitoring systems operating in the CEPT harmonized band 863 MHz to 865 MHz; Part
2: Harmonized EN under article 3.2 of the R&TTE Directive
EN 301 489-1: Electronic compatibility and Radio spectrum Matters (ERM), ElectroMagnetic Compatibility
(EMC) standard for radio equipment and services; Part 1: Common technical requirements
EN 301 489-9 (For models with FM transmitter capabilities only): Electromagnetic compatibility and Radio
spectrum Matters (ERM); ElectroMagnetic Compatibility (EMC) standard for radio equipment and services; Part
9: Specific conditions for wireless microphones, similar Radio Frequency (RF) audio link equipment, cordless
audio and in-ear monitoring devices
EN 301 489-17: Electronic compatibility and Radio spectrum Matters (ERM), ElectroMagnetic Compatibility
(EMC) standard for radio equipment and services; Part 17: Specific conditions for 2,4 GHz wideband
transmission systems and 5 GHz high performance RLAN equipment
130