Table of Contents
Advertisement
Power management
For reducing power consumption as well as maintaining the lamp
life, the Power management function turns off the projection lamp
when the projector is not used for a certain period.
If the input signal is interrupted and no button is pressed for more
than 30 seconds, the timer display with the "No signal" message
appears on the screen to start the countdown. The countdown
time can be set between 1 and 30 minutes with the Point
buttons
.
When the countdown time has been elapsed, the lamp will be
turned off to cool itself down. The POWER indicator is blinking red
during the cooling-off period. When the lamp has been fully cooled
down, the projector operates according to the selected mode.
Ready . . . . . .The POWER indicator changes to green blinking.
In this condition, the projection lamp can be
turned on when the input signal is reconnected
or any button on the top control or remote
control is pressed.
Shutdown . . . .The power will be turned off.
Off . . . . . . . . .The Power management function is off.
On start
When this function is "On," the projector is automatically turned
on just by connecting the AC power cord to an AC outlet.
✔
Note:
• Be sure to turn off the projector properly. (See "Turning Off the Projector" on page
18). If the projector is turned off in an incorrect sequence, such as disconnecting the
AC power cord before completing the cool-down etc., the On start function does not
operate properly.
Lamp mode
This function allows you to change brightness of the screen.
Normal.........normal brightness
Auto .............brightness according to the input signal
Eco................lower brightness that reduces the lamp power
consumption and extends the lamp life.
Dim mode
This function allows you to dim the projection screen contrast and
brightness. Adjust the contrast level of the Dim mode screen with
the Point
7 8
buttons to your desired brightness. (From 0 to 15.)
(p22)
Power management
Time left until Lamp off
7 8
Setting
Press the SELECT button at
Power management and this
box appears. Choose one of
three settings with the Point
7 8 buttons, and go to the
timer with the Point ed
buttons and set time with
the Point 7 8 buttons.
Press the Point 7 8 buttons
to adjust the value.
41
Advertisement
Table of Contents
