Cub Cadet CC 760 Operator's Manual page 10

Unfolding the Handle
1. Remove the star knobs and carriage screws from the lower
handle. See Figure 3-3.
2. Pivot the upper handle into operating position. Be careful
not to crimp cables. See Figure 3-4.
3. Reinstall the carriage screws and knobs removed earlier.
4. Tighten the upper and lower star knobs and carriage
screws to secure the upper handle to the lower handle. See
Figure 3-4.
5. The handle height can be adjusted to any of three
positions. For instructions, refer to Handle Height in the
Maintenance and Adjustments section of this manual.
10 S 2 — A
ection SSembly
Figure 3-3
Figure 3-4
& S -U
et p
Attaching the Shift Lever
1. Remove the screw and the lock nut that secures the shift
lever to the shift lever plate. See Figure 3-5.
Figure 3-5
2. Remove the remaining screw and nut from the lower shift
lever plate. See Figure 3-5.
3. Position the upper shift lever into a vertical position
aligning the holes in the lever with the holes in the shift
plate. See Figure 3-6.
Figure 3-6
4. Secure the lever to the plate using the two screws and two
nuts removed earlier. See Figure 3-6 inset.