Specifications - A.O. Smith EWSH PLUS 15 User Manual

Specifications

For Right Hand Side Inlet Outlet Models
Model
Volume [L]
Power [W]
Voltage/Frequency [V/Hz]
Actual Stdg. Loss [kWh/24h/45°C diff.]
Max. Stdg. Loss [kWh/24h/45 C diff.]
[as per IS 2082:1993 amended in 2002]
Reheating Time for 35°C rise [in min]
Temperature range [°C]
Rated water pressure
Inlet/Outlet connections [Inch]
For Left Hand Side Inlet Outlet Models
Model
Volume [L]
Power [W]
Voltage/Frequency [V/Hz]
Actual Stdg. Loss [kWh/24h/45°C diff.]
Max. Stdg. Loss [kWh/24h/45 C diff.]
[as per IS 2082:1993 amended in 2002]
Reheating Time for 35°C rise [in min]
Temperature range [°C]
Rated water pressure
Inlet/Outlet connections [Inch]
Note:
1. The inlet and outlet tubes are identified by blue and red ring caps respectively.
2. Please note that in all models (LHS and RHS variants) and in all configurations (wall &
floor mounted), the outlet tube should be vertically above the inlet. Refer figures 5A &
5B respectively.
3. The water heater should not be installed in any other configuration that may alter this
arrangement.
4. LHS variant should be used for left hand side plumbing connections and RHS variant
should be used for right hand side plumbing connections.
5. It is not permitted to install a RHS variant in left hand side configuration by rotating the
unit and vice versa.
6. Please note that the A. O. Smith logo visible in the front and in horizontal orientation
represents correct positioning of the unit.
o
2
N/cm
Water head (metres)
o
2
N/cm
Water head (metres)
EWSH PLUS - 15
15
2000
~230/50
0.525
1.138
20
35-75
80
80
½
EWSH PLUS 15 - LHS EWSH PLUS 25 - LHS
15
2000
~230/50
0.525
1.138
20
35-75
80
80
½
2
EWSH PLUS - 25
25
2000
~230/50
0.672
1.386
35
35-75
80
80
½
25
2000
~230/50
0.672
1.386
35
35-75
80
80
½