External Cleaning; Frost Precautions; What To Do If - AEG FAVORIT 55200VI User Manual

If necessary, do these steps to disassemble :
1. Turn the nut anticlockwise.
2. Remove the spray arm.
3. Clean the holes fully.

External cleaning

Clean the external surfaces of the appliance and control panel with a damp soft cloth. Only
use neutral detergents. Do not use abrasive products, scouring pads or solvents (acetone,
trichloroethylene etc...).

Frost precautions

CAUTION!
Do not install the appliance where the temperature is below 0 °C. The manufacturer is not
responsible for damage because of frost.
If not possible, empty the appliance and close the door. Disconnect the water inlet hose and
remove water from the water inlet hose.

WHAT TO DO IF...

The appliance does not start or stops during operation.
If there is a fault, first try to find a solution to the problem yourself. If you cannot find a
solution to the problem yourself, contact the Service Force Centre.
CAUTION!
Switch off the appliance before you do the below suggested corrective actions.
Fault code and malfunction
• intermittent audible signal
• digital display shows
The dishwasher does not fill with
water
Possible cause and solution
• The water tap is blocked or furred with limescale.
Clean the water tap.
• The water tap is closed.
Open the water tap.
• The filter in the water inlet hose is blocked.
Clean the filter.
• The connection of the water inlet hose is not correct. The
hose can be kinked or squashed.
Make sure that the connection is correct.
41
What to do if...