Setting Mode; Use Of The Appliance; Setting The Water Softener - AEG FAVORIT 55200VI User Manual

– The digital display shows the setting.
The audible signals are activated.
6. Press the function button C again.
– The digital display shows the new setting.
The audible signals are deactivated.
7. Switch off the appliance to save the operation.
Do these steps to activate the audible signals:
1. Do the above procedure until the digital display shows necessary setting.

Setting mode

The appliance is in setting mode when all the programme indicator lights are on.
The appliance must be in setting mode for these operations:
– To set a washing programme.
– To set the water softener level.
– To deactivate/activate the audible signals.
If a programme indicator light is on, cancel the programme to go back to the setting mode.
Refer to the chapter "Setting and starting a washing programme".

USE OF THE APPLIANCE

Refer to the following instructions for each step of procedure:
1. Make a check if the water softener level is correct for the water hardness in your area.
If necessary set the water softener.
2. Fill the salt container with dishwasher salt.
3. Fill the rinse aid dispenser with rinse aid.
4. Load cutlery and dishes into the dishwasher.
5. Set the correct washing programme for the type of load and soil.
6. Fill the detergent dispenser with the correct quantity of detergent.
7. Start the washing programme.
If you use detergent tablets, refer to the chapter 'Use of detergent'.

SETTING THE WATER SOFTENER

The water softener removes minerals and salts from the water supply. Minerals and salts
can have bad effect on the operation of the appliance.
Water hardness is measured in equivalent scales:
• German degrees (dH°).
• French degrees (°TH).
Audible signals deactivated
Audible signals activated
Use of the appliance
31