Epson PowerLite 450W Replacement Manual
Lamp and status information
Hide thumbs
Also See for PowerLite 450W:
- User manual (174 pages) ,
- Quick setup manual (4 pages) ,
- Brochure & specs (4 pages)
Advertisement
Quick Links
Epson PowerLite 450W / 460
Replacing the Lamp
The life span of the projection lamp is about 2500 hours if
in the Settings menu is
Consumption
hours if this setting is
ECO
It is time to replace the lamp when:
The projected image gets darker or starts to deteriorate.
The message
Replace the lamp
light ashes orange. To maintain projector brightness
Lamp
and image quality, replace the lamp as soon as possible.
You may also need to replace the lamp if the
red.
Contact your dealer or call Epson at 800-GO-EPSON
(800-463-7766). Request part number V13H010L57.
(default), and 3500
Normal
.
appears on the screen and the
Lamp
INSTALLATION HANDBOOK
Power
light ashes
Lamp and Status Information
note
Turn o this product when
not in use to prolong the life
of the projector.
1
Advertisement
Related Manuals for Epson PowerLite 450W
Summary of Contents for Epson PowerLite 450W
-
Page 1: Replacing The Lamp
To maintain projector brightness Lamp and image quality, replace the lamp as soon as possible. You may also need to replace the lamp if the light ashes Lamp red. Contact your dealer or call Epson at 800-GO-EPSON (800-463-7766). Request part number V13H010L57. - Page 2 INSTALLATION HANDBOOK Epson PowerLite 450W / 460 Lamp and Status Information Follow these steps to replace the lamp: warning 1. Turn o the projector and unplug the power cord. Let the lamp cool fully before replacing it. 2. Let the projector cool for at least an hour (if it has been on). The lamp is extremely hot immediately after use.
- Page 3 INSTALLATION HANDBOOK Epson PowerLite 450W / 460 Lamp and Status Information 5. Grasp the lamp handle as shown and pull it straight out. note The lamp(s) in this product contain mercury. Please consult your state and local regulations regarding disposal or recycling. Do not put in the trash.
-
Page 4: Resetting The Lamp Timer
INSTALLATION HANDBOOK Epson PowerLite 450W / 460 Lamp and Status Information 8. Replace the lamp cover, then tighten its screw. 9. Reset the lamp timer as described in the next section. Resetting the Lamp Timer After you replace the lamp, you need to reset the lamp timer using the projector’s menu system.