Sears 917.252641 Owner's Manual page 5

4 Connect Battew Cables using: lwo Hex Bolls lv,,n Ftal
Washers. two Lockwashers and lwo Hex Nuts (si_ov, n full
size below} and a Terminal Cover |ound in Bag o{ Parts
a Position Terminal Cover over RED Battery Cable (Fig
4}
POSITIVE TERMINAL MUST BE CON-
NECTED FIRST TO PREVENT SPARKS
FROM ACCIDENTAL GROUNDING_
b. Connect RED Battery Cable to Positive (+) Battery Ter-
minal with Hex Bolt, Flat Washer, Lockwasher and Hex
Nut (Fig 3) Form Cable in an upward position (Fig
4) and tighten securely. Place Terminal Cover over Ter.
minal. NOTE: PULL TERMINAL COVER FORWARD
TO ENCLOSE BATTERY TERMINAL (FIG, 5),
co Connect BLACK Ground Cable to Negative (-) Battery
Terminal with remaining Hex Bolt, Flat Washer, Lock-
washer, and Hex Nut. Tighten securely (Fig, 3).
5, Install Steering Wheel using Flat Washer, Hex Jam Nut
(shown full size below) and
Steering Wheel insert found in Bag of Parts,
a, Secure the Steering Wheel to Steering Shaft with Washer
and Hex Jam Nut !Fig= 6)- Tighten securely.
b, Install the Steering Wheel Insert,
NOTE: A SPARK ARRESTOR KIT (PAGE 3t) IS AVAIL-
ABLE AS AN ACCESSORY PART FOR YOUR TRACTOR.
CHECK LEGAL REQUIREMENTS IN YOUR AREA,
I T
BATTERY
/
ERMINAL
COVER
FIGURE 4
-3_
I II I IIIUIII IIIlllll
STEERING
WHEEL@
INSERT
STEERING
HEX JAM NUT _
WASHE_ WHEEL
STEERING
SHAFT
FIGURE 6