Polaris 600 RUSH Owner's Manual page 105

Track Maintenance
Track Tension
5. Check for specified slack between the wear surface of the track clip
and the plastic slider. Refer to the Track Tension Data Chart on page
100.
If the track needs adjustment:
6. Loosen the rear idler shaft bolt.
7. Loosen the locknuts.
Lock Nut
Idler
Shaft
Bolt
8. Tighten or loosen the track adjusting screws to provide equal adjust-
ment on both sides of the track.
9. Repeat the measurement on the other side of the track.
TIP: Check more frequently when the snowmobile is new.
10. Remove the weight. Start the engine and slowly rotate the track at
least five revolutions. Let the track come to a stop (do not apply
brakes).
11. Check track alignment (see page 102) and adjust as necessary.
12. Tighten the locknuts.
13. ( ) Tighten idler shaft bolts to 35 ft. lbs. (47.5 Nm).
n
Track Adjusting
Screw
I
16 (40 cm)
MAINTENANCE
Slack Measurement
Track
10 lbs. (4.54 kg)
101