Listening Through A Receiver (Home Theater); Check Points Before Requesting Service - Samsung LN-T4061F Owner's Instructions Manual

Listening through a Receiver (Home theater)

You can listen to sound through a receiver instead of the TV speaker.
1. Press the Anynet+ button.
2.
Now you can listen to sound through the receiver.
3. Press the EXIT button to exit.
When the receiver is set to On, you can listen to the TV sound through the 2-channel receiver.
If the receiver is exclusively for a home theater only (supporting audio only), it may not appear in the
device list.
Only when you have connected the optical jack of the TV and the receiver properly, does Receiver work.
In case of a content with copyright problem, listening through the receiver may not properly operate.

Check Points before Requesting Service

Symptom
Anynet+ does not work.
I want to start Anynet+.
I want to exit Anynet+.
The Connecting to Anynet+
device... message appears on the
screen.
The Anynet+ device does not play. You cannot use the play function when an auto channel scan is in progress or in
The connected device is not
displayed.
ENTER button.
ENTER button.
Solution
devices only.
WISELINK)
(HDMI-CEC) is set to On in the Anynet+ Setup menu.
TV button on the TV remote control to switch to TV. Then press the
Anynet+ button to show the Anynet+ menu and select a menu you want.
Watch TV in Anynet+ menu.
SOURCE button on the TV remote control and select a device other than
Anynet+ devices.
CH, CH LIST, PRE-CH, etc. to change to the TV mode. (Note that the channel
button operates only when a tuner-embedded Anynet+ device is not connected.)
view mode.
complete.
WISELINK mode. Stop the currently running function.
cables may not support Anynet+ functions.
English - 80
Air 28
Recevier: On
Connect Recorder
Setup
Move
Enter Exit