System Maintenance; Adding Remote Controls To Your System; Deleting Lost Or Stolen Remote Controls From Your System - Code Alarm CA-130 Owner's Manual

Remote vehicle control system
Hide thumbs Also See for CA-130:
Table of Contents

Advertisement

8
System Maintenance (cont.)

Adding Remote Controls to Your System

The Code Alarm CA-130
(8) remote controls. Follow these instructions to add a remote control to
your system.
1. Make sure the security system is disarmed and the ignition is off.
2. Open the driver's door.
3. Turn vehicle ignition on.
4. Press and hold the emergency override button.
After 10 seconds, the siren or horn will sound three (3) times.
This indicates that the unit has entered the remote control
programming mode.
5. Release the emergency override button.
6. Press the LOCK button (button 1) on the remote control to be
programmed.
The siren or horn will sound once, indicating that the system
has "learned" that remote control.
7. Repeat step 6 for any additional remote controls.
8. Turn the vehicle ignition off to exit the programming mode. Test
all remote controls to ensure that they work properly.

Deleting Lost or Stolen Remote Controls from Your System

If one of your remote controls is lost or stolen, follow these instructions
IMMEDIATELY to remove the control code from your system.
1. Have all remaining remote controls available.
2. Enter the control programming mode by following steps 1 - 5 of
Adding Remote Controls to Your System (page 8).
3a.If you have only one remaining remote control, press the
LOCK button on that remote control eight (8) times, pausing
at least 1 second between each press. Make sure that the
siren chirps each time you press the LOCK button.
3b.If you have two remaining remote controls, press theLOCK
button on each remote control four (4) times, pausing at
least 1 second between each press. Make sure that the siren
chirps each time you press the LOCK button.
3c.If you have three remaining remote controls, press the
LOCK button on the two remote controls three (3) times, then
press the LOCK button on the remaining remote control twice.
Pause at least 1 second in between each press. Make sure
that the siren chirps each time you press the LOCK button.
4. Turn the vehicle ignition off to exit the programming mode.
When you are finished, the lost or stolen remote control will no
longer operate your system.
CA 130 owners rev 7-04.pmd
TM
has the ability to operate from up to eight
8
7/28/2004, 3:34 PM

Advertisement

Table of Contents
loading

Table of Contents