Web Browser Management - TRENDnet TV-IP562WI User Manual

TRENDnet User's Guide
17. Wait a few minutes allow wireless connection be setting up.
18. When the Setup Wizard has finished, the configuration is complete and the
following screen appears:
© Copyright 2014 TRENDnet. All Rights Reserved.

Web Browser Management

After completing the AutoRun Wizard from the CD, you are ready to use your
camera. The camera's built-in Web configuration utility is designed to allow you to
easily access and configure your TV-IP562WI camera. Open a web browser such as
Internet Explorer® and enter the IP address of your camera (through the setup wizard
utility software on the CD). To log in, type the Username admin and the password you
created in the Autorun Wizard. If you did not create a password or you just press the
reset button for reset, the default password is admin. After entering your password,
click OK.
Note: By default, this camera obtains an IP address from a DHCP server on the local
network. To find the IP address of the camera, consult the DHCP client list on the DHCP
server on your wireless router or install the Setup Wizard utility software from CD.
However, if there is no DHCP server available, the static default IP address of this
camera is 192.168.10.30, in case you are connecting the camera directly with your PC
without another device in-between.
These initial steps are using Internet Explorer.
To log in, type the Username admin and the password you created in the Setup Wizard.
If you did not create a password, the default password is admin. After entering your
password,
TV-IP562WI
click OK.
22