Table of Contents
Advertisement
Some installations may require door reversal to achieve
full door swing. If so proceed to Door Reversal section
before leveling refrigerator.
If your refrigerator requires ice maker water supply
connection, proceed to Connect Ice Maker Water Supply
section before leveling refrigerator.
1. Plug in power cord.
2. Move refrigerator into final location.
3. Level refrigerator using a level placed on top of the
refrigerator.
• Remove toe grille. Remove bottom hinge cover if
refrigerator has a stabilizing leg.
3
• Turn
/
" hex head roller adjustment screws to raise
8
or lower refrigerator cabinet. Front of refrigerator
must be
1
/
" (6 mm), or
4
than the back of refrigerator.
• Make sure refrigerator cabinet is level from side to
side by adjusting left and right roller adjustment
screw. Turn stabilizing leg (some models)
clockwise until firmly against floor.
Roller adjustment
screw
Bottom
hinge cover
Door Removal
Some installations may require door removal for
refrigerator to fit through door ways. If door removal is
required perform steps 2–5 of Door Reversal section to
remove doors. Perform steps 2–5 of Door Reversal
section in reverse order to replace doors.
Door Reversal
Tools Required
Putty knife (blade covered with masking tape)
9
/
" hex nut driver (some models)
32
3
/
" hex nut driver
8
Phillips screwdriver
Blade screwdriver
Some installations require door reversal to achieve full
door swing. To reverse door swing perform the following:
1. Remove and reverse refrigerator and freezer
handles performing the following steps:
1
/
bubble on level, higher
2
Stabilizing leg
(some models)
Important: To prevent scratching refrigerator surfaces,
blade of screwdriver and putty knife called for in steps
following must be covered with masking tape.
• Remove end caps from top (some models) and
bottom of refrigerator door handle using a
screwdriver with blade covered in masking tape.
(See illustration following.) Remove one bottom
and two top handle screws to remove handle.
• Models with automatically reversing logo.
Remove end cap from top of freezer handle using
a screwdriver with the blade covered with masking
tape. (See illustration below.) Remove one top and
two bottom mounting screws.
• Handles with removable logo on handle.
Remove screw caps from handles using a
screwdriver with the blade covered in masking
tape. Remove handle screws to remove freezer
handle. Remove freezer handle cover by lifting
end. Bend tabs behind nameplate up and remove
nameplate. Rotate nameplate and cover.
Mounting
screws
3
Handle
screws
or
End
cap
Handle with
removeable logo
End
caps
End
cap
Advertisement
Table of Contents
