How To Control The Unit - American DJ Fusion FX Bar 4 User Manual

button and all channels of the unit will return to their standard position. To go back to the
functions without any change press the MENU button again.

4. How To Control The Unit

You can operate the unit in three ways:
1. By master/slave built-in preprogram function
2. By easy controller
3. By universal DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be effected at once. Every time you turn the unit on, it will show
display, after that the unit will be ready to receive DMX signal or run the built in programs.
4.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to
give an automatic, sound activated, synchronized light show. This function is good when you
want an instant show. You have to set the first unit in
(show 1) or ... or
(show 0) or
have nothing plugged into it, Its master LED will be constantly on and sound LED will flash to
the music. The other units will have to set in
mode), Their DMX cables plugged into the DMX input jacks (daisy chain) and the slave led
lights will constantly on.
2-light show
In slave mode, means the unit works normally and
order to create a great light show, you can set
movement to each other, even if you have two units only.
(master mode) and select
(show 6). Its DMX input jack will
(slave 1 mode) or (slave 2
means 2-light show. In
on the second unit to get contrast
8
4.2 Easy Controller
The easy remote control is used only in master/slave mode. By connecting to the 1/4"
microphone jack of the first unit, you will find that the remote control on the first unit will
control all the other units functions press the MENU button again.
Stand By Blackout the unit
Function 1. Ø 5 LED Strobe
2. Moon flower strobe
Mode
on the
4.3 DMX Controller
Using universal DMX controller to control the units, you have to set DMX address from 1 to
512 channel so that the units can receive DMX signal.
Press the MENU button up to when the
button and the display will blink. Use DOWN and UP button to change the DMX512 address.
Once the address has been selected, press the ENTER button to store or it will
automatically return to the main functions without any change after idling 8 seconds. To go
back to the main functions without any change press the MENU button. Please refer to the
following diagram to address your DMX512 channel for the first 4 units：
Select show
Show1-6
Sound (LED OFF) LED ON
is showing on the display. Pressing ENTER
9