Epson EPL-N2700 Reference Manual page 115

Standby
Saves power by reducing the power to the fixing heater if the
printer receives no data for 60 minutes. In this mode, the printer
begins warming up as soon as you send a print job; it then warms
up and is ready to print in about 60 seconds at rated voltage.
Lang
Specifies the language displayed on the LCD panel and printed
on the status sheet.
Toner
Displays the amount of toner left in the imaging cartridge as
shown below:
E****F
E*** F
E** F
E* F
E F
Multibin
Selects the mode setting for the optional 5-Bin or 10-Bin Multi-
Purpose Units. If you want to change the settings for a multibin
unit, always consult your printer's administrator and inform all
other users to avoid confusion. Changing these settings often is
not recommended.
Note:
After changing these settings, reboot the printer to make the new
settings effective. To reboot the printer, press the Continue and
SelecType buttons simultaneously. Alternatively, turn off the
printer, then after 5 seconds, turn it back on.
5-18
SelecType Settings
100-75%
75-50%
50-25%
25-0%
(0%)