Outdoor Unit; Indoor Unit - Daikin Inverter FLXS25BVMB Operation Manual

■ Outdoor Unit

16

Indoor Unit

■
1. Louvers (vertical blades):
The louvers are inside of the air outlet.
(page 12.)
2. Air outlet
3. Flap (horizontal blade): (page 12.)
4. Panel tab
5. Air inlet
6. Display
7. Air filter
8. Photocatalytic deodorizing filter or
Air purifying filter:
• These filters are attached to the inside of the air
filters.
9. Front panel
10. Operation lamp (green)
11. TIMER lamp (yellow): (page 18.)
12. HOME LEAVE lamp (red):
Lights up when you use HOME LEAVE
Operation. (page 16.)
■ Outdoor Unit
15. Air inlet: (Back and side)
16. Air outlet
17. Refrigerant piping and inter-unit cable
Appearance of the outdoor unit may differ from some models.
15
13. Indoor unit ON/OFF switch: (page 10.)
14. Signal receiver:
18. Drain hose
19. Earth terminal:
• Push this switch once to start operation.
Push once again to stop it.
• The operation mode refers to the following
table.
Temperature
Mode
FLKS COOL
FLXS AUTO
• Push the switch using an object with a sharp
tip, such as a pen.
• This switch is useful when the remote controller
is missing.
• It receives signals from the remote controller.
• When the unit receives a signal, you will hear a
short beep.
• Operation start .............beep-beep
• Settings changed..........beep
• Operation stop ..............beeeeep
• It is inside of this cover.
17
18
19
Air flow
setting rate
22°C AUTO
25°C AUTO
5