Baxi Brazilia F5 Installation And Owner's Manual page 5

© Baxi Heating U.K. Limited 2010.
Discolouration of wall surfaces
Most heating appliances generate warm air convection
currents and transfer heat to any wall surface against
Some soft furnishings (such as blown vinyl wallpapers)
may not be suitable for use where they are subject to
temperatures above normal room levels and the
manufacturer's advice should be sought before using this
type of wall covering adjacent to any heating appliance.
The likelihood of wall staining from convected air currents
will be increased in environments where high levels of
tobacco smoke or other contaminants exist.
1.3 Important Information
This product uses insulation board and gaskets containing Refractory Ceramic Fibres (RCF), which are man-made vitreous
silicate fibres. Excessive exposure to these materials may cause irritation to eyes, skin and respiratory tract. Consequently, it is
important to take care when handling these articles to ensure that the release of dust is kept to a minimum. To ensure that the
release of fibres from these RCF articles is kept to a minimum, during installation and servicing we recommend that you use a
HEPA filtered vacuum to remove any dust and soot accumulated in and around the fire before and after working on the fire.
When replacing these articles we recommend that the replaced items are not broken up, but are sealed within a heavy duty
polythene bag, clearly labelled as RCF waste. RCF waste is classed as a stable, non-reactive hazardous waste and may be
disposed at a landfill licenced to accept such waste. Protective clothing is not required when handling these articles, but we
recommend the use of suitable gloves to prevent irritation. We also recommend you follow the normal hygiene rules of not
smoking, eating or drinking in the work area and always wash your hands before eating or drinking.
This appliance does not contain any component manufactured from asbestos or asbestos related products.
Notice
which they are situated.
Installer Guide
1.0 Introduction
1.2 Installation
1. The appliance is suitable for installation only in
G.B. and I.E. and should be installed in
accordance with the rules in force. For Ireland
install in accordance with I.S.813 "Domestic gas
installations". In the UK the installation must be
carried out by a Gas safe register Installer or other
competent person (GAS SAFE REGISTER or
CORGI engineer outside of UK) and be in
accordance with the relevant requirements of Gas
Safety (Installation and Use) Regulations latest
edition, the Building Regulations issued by the
Department of the Environment, Building
Standards (Scotland) (Consolidation) Regulations
issued by the Scottish Development Department
and the Local Building Regulations. Where no
specific instructions are given, reference should be
made to the relevant BRITISH STANDARD CODES
OF PRACTICE.
2. This appliance must be installed in
accordance with the manufacturers
instructions and the rules in force.
3. Read the instructions before installing or
using this appliance.
NOTE: All illustrations show F 5S, unless
otherwise indicated. The procedure for
installation, commissioning, servicing etc. is the
same for all Brazilia F models.
B.S. Codes of Practice
STANDARD SCOPE
B.S. 6891 Gas Installation.
B.S. 5440: Pt. 1 Flues.
B.S. 5871 Pt.1 Installation of fires, convector
heaters
5