Cleaning Your Hard Floors - Shark SK410 series Owner's Manual

Using Your Steam & Spray
IMPORTANT: When cleaning, do not use
the Steam & Spray Mop without attaching a
™
Cleaning Pad, the Steam Energized
bottle, and filling the water tank first.
fig. 6
fig. 7

Cleaning Your Hard Floors

Filling the Water Tank:
1 Turn the water tank cap counter clockwise and
remove from the unit. (Fig. 6)
2 Using the filling flask, pour water into the water
tank. Do not overfill. Replace the cap on the
water tank. (Fig. 7)
NOTE: To prolong the life of your Steam & Spray
Mop, we recommend using distillied water.
3
Insert the Steam Energized
the unit upside down. Push it down to make sure
that it is well inserted. You will hear an audible
"Click" when the Cleanser bottle is inserted
properly. (Fig. 8)
4 TOLL FREE: 1-800-798-7398
Mop
™
Cleanser
™
™
™ Cleanser bottle into
IMPORTANT: When you are using the mop
for the first time, it might take longer than the
normal 30 seconds to start steaming.
fig. 8
IMPORTANT: Do not use on unsealed wood
or unglazed ceramic floors. Do not use on wood
or tile floors that are highly worn, unfinished or
have a wax or oil finish. Surfaces that have been
treated with wax or some no wax floors may be
damaged by the cleaning solutions therefore it is
always recommended to test an isolated area of
the surface to be cleaned before proceeding. You
should always check the use and care instructions
from the floor manufacturer.
IMPORTANT: Make sure the floors are swept
or vacuumed before using the Steam & Spray
Mop.
Visit www.sharkclean.com for other great quick
cleaning products to complement your Steam &
Spray Mop, such as the Shark
™
vacuums.
4 Twist the quick release cord holder to unwrap
the power cord completely. Plug into an
electrical outlet.
5 Make sure that the Cleaning Pad is attached to
the mop head.
™
Rotator
® ™