Maintaining Your Vacuum; Emptying The Dust Cup; Cleaning The Filters - Shark Rocket Deluxe Pro UV330 Owner's Manual

MAINTAINING YOUR VACUUM

IMPORTANT: Clean the
dust screen inside the
dust cup as required�
NOTE: Empty dust cup
when debris reaches the
MAX fill line�
RECOMMENDED
FILTER CLEANING
SCHEDULE:
Pre-Motor Filter Kit
(Foam & Felt)
XPMFK320
Clean once a month�
Post-Motor Filter
1084FTV320
Clean once a year�

EMPTYING THE DUST CUP

1 Press the Wand Release button on the top of the
wand to disconnect it from the handheld vacuum�
Remove the dust cup from the handheld vacuum
by squeezing the two Dust Cup Release buttons on
both sides of the base at the same time, then pull
out the dust cup�
13
1-800-798-7398
STEP 1
Empty
OR
STEP 2
Empty
2 Hold dust cup over a trash bin and
press the Empty button on the front
of the dust cup� The bottom lid will
open, allowing the debris to fall out�
3 Once dust cup is empty, close the
bottom lid and insert dust cup back
into handheld vacuum, pressing it in
until it clicks into place�
Monthly
Pre-Motor filters
Foam
Felt
Post-Motor filter

CLEANING THE FILTERS

1 Access the Pre-Motor foam and felt
filters by lifting the latch on the top
of the handheld vacuum� Remove
and rinse the filters with water� DO
NOT use soap� Tap loose dirt off
filters between washes as needed�
Allow filters to air-dry completely,
then reinstall them� Insert the felt
filter first, then place the foam filter
on top of it�
2 Access the Post-Motor filter under
the handle� Remove and rinse the
filter with water� DO NOT use soap�
s h a r kc l e a n . c o m
14