Table of Contents
Advertisement
d d e e c c i i d d i i n n g g o o n n c c o o m m p p o o n n e e n n t t l l o o c c a a t t i i o o n n s s
l l o o c c a a t t i i o o n n s s f f o o r r t t h h e e s s i i r r e e n n
S S o o m m e e t t h h i i n n g g s s t t o o r r e e m m e e m m b b e e r r a a b b o o u u t t m m o o u u n n t t i i n n g g t t h h e e s s i i r r e e n n : :
■ Keep it away from heat sources, such as radiators, exhaust manifolds, turbochargers, and heat shields.
■ Mount it where a thief cannot easily disconnect it, whether the hood is open or shut. Both the siren and its
wires should be difficult to find. This usually involves disguising the wire to look like a factory harness.
■ We recommend against grounding the siren to its mounting screws. Instead, we recommend running both the
red and black wires into the passenger compartment and grounding to one common point for all devices.
After all, both wires are the same length and come already bonded together. Whenever possible, conceal your
wires in the factory harnesses or in the same style loom as the factory.
■ When possible, place the siren on the same side of the vehicle as the control module, where its wires will
reach the control module's wires without extending them. Always run the wires through the center of a
grommet, never through bare metal!
■ Point the siren down so water does not collect in it.
l l o o c c a a t t i i o o n n s s f f o o r r t t h h e e c c o o n n t t r r o o l l m m o o d d u u l l e e
S S o o m m e e t t h h i i n n g g s s t t o o r r e e m m e e m m b b e e r r a a b b o o u u t t w w h h e e r r e e t t o o m m o o u u n n t t t t h h e e c c o o n n t t r r o o l l m m o o d d u u l l e e : :
■ Never put the control module in the engine compartment!
■ The first step in hot-wiring a vehicle is removing the driver's side under-dash panel to access the starter and
ignition wires. If the control module is placed just behind the driver's side dash it can easily be disconnected.
■ When mounting the control module, try to find a secure location that will not require you to extend the har-
nesses' wires (they are 1.5 meters long). Keep it away from the heater core (or any other heat sources) and
any obvious leaks.
■ Some good control module locations are: Above the glove box, inside the center console, above the under-
dash fuse box, or above the radio.
6 6
© 2005 Directed Electronics—all rights reserved
Hide quick links:
Advertisement
Table of Contents
