Clifford RSX3.5 Installation Manual page 20

H H 1 1 / / 1 1 1 1 W W H H I I T T E E ( ( + + / / - - ) ) s s e e l l e e c c t t a a b b l l e e l l i i g g h h t t f f l l a a s s h h o o u u t t p p u u t t
As shipped, this wire should be connected to the (+) parking light wire. If the light flash polarity jumper under
the sliding door is moved to the opposite position (see Internal Programming Jumper section of this guide), this
wire supplies a (-) 200 mA output. This is suitable for driving (-) light control wires in Toyota, Lexus, BMW, some
Mitsubishi, some Mazda, and other model cars.
N N O O T T E E : : For parking light circuits that draw 10 amps or more, the internal jumper must be switched
to a (-) light flash output. (See the Internal Programming Jumper section of this guide.) P P / / N N
8 8 6 6 1 1 7 7 or a standard automotive SPDT relay must be used on the H1/2 light flash output harness
wire.
2 2 0 0
( ( + + ) ) P P o o s s i i t t i i v v e e L L i i g g h h t t F F l l a a s s h h O O u u t t p p u u t t
( ( - - ) ) L L i i g g h h t t F F l l a a s s h h O O u u t t p p u u t t
© 2005 Directed Electronics—all rights reserved