Compass Zone/Calibration Adjustment - Ford Expedition 2008 Owner's Manual

Driver Controls
degrees between adjacent zones and will become noticeable as the
vehicle crosses multiple zones. A correct zone setting will eliminate this
error. Refer to Compass zone/calibration adjustment.

Compass zone/calibration adjustment

1. Determine your magnetic zone by
referring to the zone map.
2. Turn ignition to the ON position.
3. Start the engine.
4. From Setup menu, select the
Update Zone function.
5. Press and release the RESET
until the message center displays a
selection to change the current zone
setting.
6. Press and release the RESET
control until the message center
display changes to show the current
zone setting (XX).
7. Press and release the RESET
control repeatedly until the correct zone setting for your geographic
location is displayed on the message center. The range of zone values are
from 1 to 15 and "wraps" back to 1.
8. To exit the zone setting mode,
and to "lock in" your change:
• press and release the SETUP
control or,
• press INFO control to exit or,
• wait 4 seconds and the zone will
be "locked in".
Perform compass calibration in an open area free from steel structures
and high voltage lines. For optimum calibration, turn off all electrical
accessories (heater/air conditioning, wipers, etc.) and make sure all
vehicle doors are shut.
134
2008 Expedition (exd)
Owners Guide (post-2002-fmt)
USA (fus)
3 2 1
4
5
6 7 8 9 1011
15
14
13
12