Sony HT-SF470 Operating Instructions Manual page 69

HDMI
The source sound input to the HOMI
jack on the receiver is not output from
the receiver or the TV speaker.
• Check the HDMI connection (page 21).
• Make sure "CTRL HDMI" is set to
"CTRL ON" in SET HDMI menu.
• You cannot listen to the Super Audio CD
by connecting HDMI.
• Depending on the playback component,
you may need to set up the component.
Refer to the operating instructions
supplied with each component.
• Be sure to use a High Speed HDMI cable
when you view images or listen to sound
during Deep Color or 3D* transmission.
The source image input to the HOMI
jack on the receiver is not output from
the TV.
• Check the HDMI connection (page 21).
• Depending on the playback component,
you may need to set up the component.
Refer to the operating instructions
supplied with each component.
• Be sure to use a High Speed HDMI cable
when you view images or listen to sound
during Deep Color or 3D* transmission.
The Control for HOMI function does not
work.
• Check the HDMI connection (page 21).
• Make sure "CTRL HDMI" is set to
"CTRL ON" in SET HDMI menu.
• Make sure the connected component is
compatible with the Control for HDMI
function.
• Check the Control for HDMI settings on
the connected component. Refer to the
operating instructions of the connected
component.
• Repeat the procedures of "Preparing for
the "BRAVIA" Sync" if you change the
HDMI connection, connect/disconnect the
AC power cord, or there is a power failure
(page 39).
No sound is output from the receiver
and TV speaker while using the System
Audio Control function.
• Make sure the TV is compatible with the
System Audio Control function.
• If you cannot listen to the sound of a
component connected to the receiver
- Select the appropriate input when you
want to watch a program on a
component connected via HDMI
connection to the receiver.
- Change the TV channel when you want
to watch a TV broadcast.
- Select the component or input you want
to watch when you watch a program on
the component connected to the TV.
Refer to the operating instructions of the
TV on this operation.
When the receiver is in standby mode,
there is no image or sound on the TV.
• When the receiver is in standby mode,
image and sound are output from the
HDMI component selected the last time
you turned off the receiver. If you are
enjoying other component, play the
component and perform the One-Touch
Play operation, or tum on the receiver to
select the HDMI component you want to
enJoy.
• Make sure "PASS THRU" is set to
"THRU ON" in the SET HDMI menu if
you connect components not compatible
with the "BRAVIA" Sync to the receiver
(page 44).
The volume turns down when the
output method changes from the TV
speaker to the speakers connected to
the receiver.
• The Volume Limit function is working
(page 42).
*Except for HT-SS370, models of area code U2
only
•
»
Q.
Q.
;::;
o·
::::s
Q)
::::s
0-
'"'l
3
Q)
-
o ·
::::s
conNnued-----------
69
US