Opening And Closing The Front Bezel; Removing The Front Bezel - Fujitsu PRIMERGY TX100 S2 Service Supplement Manual

Replacement routines
4.1.3

Opening and closing the front bezel

4.1.3.1

Removing the front bezel

Part number: C26361-K1007-B867
The following replacement routines require removing the front bezel:
– Replacing the front panel cable
– Replacing the front USB module
Ê Shut down the server and disconnect the AC power cord from the system.
Ê You are advised to
– either bring the server to its upright position
– or lay the server on its side with the chassis slightly elevated above the
detached front bezel.
Ê Remove the side cover as described in section
Ê Remove all accessible drives and dummy covers as described in sections
4.1.5.1 on page 39
I
In order to fully remove the front bezel, you first have to disconnect the
front panel cable from the system board and detach it from the cable
cable clamps.
Ê Open the HDD cage as described in section
Ê Remove the air duct as described in section
Ê Remove the front fan module as described in section
28
and 4.1.6.1 on page
Service Supplement
4.1.1.1 on page
41.
4.1.2.1 on page
4.1.4.1 on page
4.6.1 on page
23.
25.
33.
72.
TX100 S2