Using The Webbios Configuration Utility - IBM 4190 User Manual

To clear CMOS and reset the passwords, complete the following steps.
Note: All configuration settings will be cleared by this action; you might have to
configure the settings again.
1. Review the safety information that begins on page v.
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Remove the server from the rack and place it on a flat, static-protective surface.
4. Remove the cover. See "Removing the cover" on page 22 for instructions.
5. If necessary, remove the riser-card assembly. See "Installing an adapter" on
6. Move the clear-CMOS jumper from pins 1 and 2 to pins 2 and 3 and leave it
7. Reinstall the riser-card assembly and cover. See "Installing an adapter" on page
8. Replace the server in the rack and connect the server to a keyboard, monitor,
9. Turn on the server. You can now start the Configuration/Setup Utility program

Using the WebBIOS Configuration Utility

Use the WebBIOS Configuration Utility program to configure hot-swap hard disk
drives that are connected to the ServeRAID-MR10i controller.
To start the WebBIOS Configuration Utility program, complete the following steps:
1. Turn on the server.
50
IBM System x3250 M2 Types 4190 and 4194: User's Guide
Clear CMOS jumper
external cables.
page 23 for instructions.
there for at least 5 seconds; then, move the clear-CMOS jumper back to pins 1
and 2.
23 for instructions.
and mouse; then, connect the server to a power source.
and either delete the old password or set a new power-on or administrator
password.
SAS/SATA
controller
card