Autopage NG-100 Installation And User Manual page 14

Once your system has restarted you will need to choose the USB slot the receiver will remain in. This
will determine the USB address for the devise. This cannot be changed at a later time unless the
software is reinstalled. Please use the same USB slot when running the Night Guard system.
„
Plug in the USB receiver and wait for the confirmation beeps from your computer,(two Beeps)
„
Your computer should start looking for the correct USB drivers installed with your software program.
„
If the computer recognizes the software driver, you are ready to begin using the program.
„
If your computer does not properly install the software, extra steps need to be taken for Night Guard
operation. This can be checked by accessing the "devise manager" folder of your computer. This can be
found in your control panel in the systems folder. Please see the examples below.
Fig. 5
Fig. 7
14
Fig. 6