Table of Contents
Advertisement
CME-5200 Digicast Media Router ASI Receiver
Installation & Initial Configuration
•
2.3
Installation
The ASI-R is designed for ease of installation and configuration. Once the unit has
been removed from the packing container, please follow these instructions:
Step
1
2
3
4
5
6
7
Comtech EF Data Customer Support if the shipment is:
Contact
!
Incomplete
!
Physically damaged
!
Inoperable
Procedure
Place the ASI-R on a flat surface with free-air flow where the LEDs can be
clearly observed with unrestricted access to the rear panel of the unit.
Connect the DC power connection to the connection labeled PWR on the
back of the unit and tighten the restraining nut to ensure secure operation.
Connect an RJ-45 Ethernet cable (patch cord) to the port labeled
ETHERNET. This cable should be connected to an Ethernet concentrator
(hub) or switch.
Connect a terminal cable (supplied) to the port labeled TERM. This cable
should be connected to a PC's serial port (DB-9) to initially configure the
ASI-R.
Connect the AC power cord between a standard wall outlet and the power
supply. The blue LED will illuminate.
It is recommend that the ASI cable NOT be connected until the
unit has been completely configured.
IMPORTANT
Upon startup, the following LEDs will illuminate on the ASI-R front panel:
LED
Function Label
Blue
POWER
Red
ALARM
Green
M-ACT
Green
E-ACT
Green
E-LINK
LED illuminates if power is properly applied
LED may illuminate since the unit is not yet
configured
LED illuminates if MPE data is present
LED flashes if there is Ethernet traffic/activity
LED illuminates if the Ethernet connection to
the Hub/Switch is operational
2-2
Revision A
MN/MRASIRCDC.IOM
Description
Advertisement
Table of Contents
