Table of Contents
Advertisement
Figure 135. Select SNMP Trap Types Pop-Up Window
Configuring SNMP Trap Destinations
Once the Library Manager Trap Types have been selected, the Library Manager
needs to be configured to send the SNMP traps to the correct monitoring station. To
do this, select SNMP Options from the Commands menu, and then select Change
SNMP trap destinations.
The Library Manager can be configured to send SNMP traps to a maximum of five
different trap destinations.
Note: If this is a High Availability 3494, only the active Library Manager needs to
The procedure for configuring the SNMP trap destination depends on the OS/2
version (2.11 or 4.0). To determine which version of OS/2 you have, choose About
from the Help menu. (See "Using the Help Pull-Down" on page 94.) Procedures for
both versions of OS/2 are shown below.
OS/2 Version 2.11: Figure 136 on page 211 shows the OS/2 2.11 version of the
Change SNMP Trap Destinations pop-up window.
210
Magstar 3494 Tape Library Operator Guide
be configured. The Library Manager code will automatically configure the
standby Library Manager when the standby Library Manager becomes
active. Only the Active Library Manager will send trap messages.
Advertisement
Table of Contents
