KYMCO DINK 125 Owner's Manual page 69

2. Place a drain pan under the crankcase and remove
the oil strainer screen cap (2).
The spring (3) and oil strainer screen (4) will come out
when the drain plug is removed.
Let the engine oil drain out.
3. Clean the oil strainer screen.
4. Check that the oil strainer screen, sealing rubber and
drain plug O-ring are in good condition.
5. Install the oil strainer screen, spring and oil strainer
screen cap.
Oil strainer screen cap torque:
5. Fill the crankcase with the recommended grade oil
(see page 58) and install the oil filler cap.
Oil capacity (after draining):
6. Start the engine and let it idle for 2 3 minutes.
7. Stop the engine and check that the oil level is at the
upper level mark on the oil filler cap/dipstick with the
scooter upright on firm, level ground. Make sure there
are no oil leaks.
15N-m (1.5 kgf-m, 11lbf-ft)
0.9 liter (0.95 US qt, 0.8 lmp qt)
－
63
(2)
(4)
(3)
(2)