Mitsubishi Electric FR-S500 Series Instruction Manual page 34

7.
Mode/monitor check
MODE
Press twice to choose the
monitor/frequency monitor.
8. Turn the start switch (STF or
STR) on.
The motor runs at the frequency
set in the set frequency mode
of the operation panel.
9.
Turn to change running frequency.
Display the frequency you want to set.
The frequency flickers for about 5s.
10.
While the value is flickering,
press to set the frequency.
SET
If you do not press
flickers for about 5s and the display
then returns to 0.00 (display) Hz.
At this time, return to "Step 8" and
set the frequency again.
11.
Turn the start switch (STF or
STR) off.
The motor decelerates according
to Pr. 8 "Deceleration time" to stop.
REMARKS
• To make a reverse rotation start, Pr. 63 "STR terminal function selection" must be set to "---".
(factory setting)
• When Pr. 79 "Operation mode selection" is set to "3", multi-speed operation (refer to page 30)
is also made valid.
When the inverter is stopped by
and
1. Turn the start switch (STF or STR) off.
2. The display can be reset by
Forward
rotation Reverse
ON
, the value
SET
Forward
rotation
OFF
STOP
of the operation panel,
RESET
RUN
Flickering
are displayed alternately.
PU
EXT
PU
EXT
29
Operation by the start command of the terminal block
MODE
rotation
Flickers for about 5s
SET
Flicker
Parameter setting complete
Reverse
rotation
Stop
.
(external operation)
RUN
PU
EXT
RUN
PU
EXT
4