Wiring The Ring And Spade Connectors; Power - Rockford Fosgate Punch Owner's Manual

Wiring the 1 . Strip back approximately 3/8" (1 cm) of insulation.
Ring and
Spade
Connector:
2 . Insert the bare wire into the connector and crimp in

Power

The gold B+ terminal on the amplifier must be connected
directly
appropriate size fuse. (See the Specifications Table for
more information.) This provides a power source with a
low voltage drop and low noise. Be sure to use the
supplied fuse and fuse holder within 18" (46cm) of
the battery's positive terminal. Failure to do so may
cause damage to the vehicle and the amplifier.
If the power wire must be extended beyond 17' (518cm),
we recommend you use 8 gauge, or heavier, stranded
wire.
If using a larger gauge wire than that supplied with your
Using Larger
Gauge Wire
new Punch 4-Channel, cut the wire casing on the diago-
nal as shown in the following diagram. Insert the wire into
the connector. Twist the wire around so that the long end
of the insulation faces up. Bend the wire prior to tightening
in place. This will make it easier for attaching the end cap
to the amplifier.
Note: For easier assembly, only 5/8" (1.6cm)
should be bare.
place as shown in the following diagram:
Crimp Here
to the positive (+) terminal of the battery with an
This connector is used for
the Red Power wire and
Black Ground wire.
This connector is for the
Blue Remote Turn-On wire.
1 2
of wire