Philips FW-C255 Service Manual page 8

Dismantling of the Cassette door Lenses
1) Loosen the Lens Cassette Strip Left Top (pos 163) by
pushing it towards the inside as indicated in Figure 7 and
remove it by using a minus screw driver force it out as
indicated in Figure 8.
Push in this
direction
Push in this
direction
Figure 7
Dismantling of the Bottom & Rear Panel assembly
1) Loosen 5 screws D mounting the Combi board to the Rear
Panel (pos 254) as shown in figure 9.
2) Loosen 3 screws E and release the 2 catches on the sides
of the Rear Panel to separate it from the Bottom plate (pos
227).
3) Loosen 4 screws G to remove the Mains Transformer.
5) Loosen 2 screws F to remove the Combi Board.
Figure 9
2-2
2) Remove the Lens Cassette Left (pos 161) by pushing it
towards the inside as indicated in Figure 7. Be careful not
to damage or break the catch A.
3) Do likewise for the right Cassette Door Lens (pos 160 and
162).
Use a minus screw
driver to push the Lens
in the direction shown
Catch A
Figure 8
Figure 10
Service pos A
Service pos B
2-2
Note: After re-assembly, it is very important to ensure all
wires are routed properly to ensure that they do not
touch/obstruct all moving parts.
The 3CDC Module can be complete detached while
repair the other portion of the set.