Table of Contents
Advertisement
Modify/View Interface Values Menu - Firmware Rev
Interface Type
1. Port
2. Port Type
3. Serial port IP address
4. Serial port subnet mask
5. Serial port speed
6. Serial port mode
7. Serial port hardware flow control
8. Modem Init String
9. Modem Hangup String
10. Modem Connect Responses
11. Modem No-Connect Responses
S. Save Changes and Exit
0. Cancel Changes and Exit
Figure 2-10: Modify/View Serial Port Settings Menu
2. Select each field requiring configuration (one at a time) by selecting its
corresponding number as shown in Figure 2-10 and then entering the values
that are appropriate for your modem's serial port.
Serial port IP address
Serial port
subnet mask
Serial
1.2/Serial
Not Applicable
0.0.0.0
255.255.252.192
9600
Direct
On
^s^M^d1^sATE0Q0V1X4 S0=1...
^d2^s+++^d2^sATH0^M^d2
/CONNECT/300/CONNECT/1200/...
/NO CARRIER/BUSY/NO DIALT...
Press 3 and then enter the serial port IP address for the
probe. The default Serial Port IP Address is 0.0.0.0.
Press 4 and then enter the serial port subnet mask for
the probe (optional). It is recommended that you do not
change the serial port subnet mask unless there is a
conflict. The default Serial Port Subnet Mask is
255.255.255.192.
Local Terminal Configuration
Using a Local Terminal
25
Advertisement
Table of Contents
