Table of Contents
Advertisement
Local Terminal Configuration
Using a Local Terminal
2. Select each field requiring configuration (one at a time) by pressing its
corresponding number and then entering the values that are appropriate for
your network.
Port
Port Type
IP Address
Default Gateway
IP Address
Subnet Mask
Parameters do not take effect until you select the Save Changes and Exit
menu item.
3. Press S to save the configuration changes and return to LanProbe's Main
Menu. If you want to cancel your current changes and return to the
LanProbe's Main Menu, press 0 .
22
Press 1 and enter the port number to be configured. Refer to
"Display Interface Summary" on page 23 for interface
summary information. After you enter a port number, the
configuration parameters are shown along with their current
settings for the specified port number. You can then view or
configure the port's parameters. The following are your port
choices:
[1] 1.1/Ethernet
[2] 1.2/Serial
Refer to "Modify/View Serial Port Settings" on page 24 for
information on configuring the Serial Port settings.
Press 2 and select the port type as Telemetry or Serial Port.
Press 3 and enter the IP address for the probe. If the IP
address is 0.0.0.0, LanProbe will transmit Bootp Requests
for configuration information (including IP address) over the
network.
Press 4 and enter the default gateway IP address for the probe
(optional).
Press 5 and enter the subnet mask for the probe.
Advertisement
Table of Contents
