Table of Contents
Advertisement
For some models, you need to apply two FCC labels. Check the old base cover; if it has two FCC labels,
apply both to the new base cover.
2010 LCD unit
For access, remove these FRUs in order:
•
"1010 Battery pack" on page 50
•
"1020 Bottom slot cover" on page 51
•
"1040 Hard disk drive or solid state drive assembly" on page 53
•
"1070 Keyboard" on page 57
•
"1090 Top case assembly" on page 60
• "1130 System board assembly, fan assembly, and backup battery" on page 65
Table 27. Removal steps of LCD unit
1
In step
, release the antenna cables from the cable guides.
When installing:
• Make sure that the cables are attached to the cable guides firmly.
• When you route the cables, make sure that they are not subjected to any tension. Tension could cause the cables
to be damaged by the cable guides, or a wire to be broken.
.
Chapter 8
Removing and replacing a FRU
71
Advertisement
Table of Contents
