Directed Electronics 671XV Installation Manual page 6

is pressed. This output can be programmed to provide the following types of output (see System
Features Learn Routine section of this guide):
A v v a a l l i i d d i i t t y y output will send a signal as long as the transmission is received.
A l l a a t t c c h h e e d d output will send a signal continuously when the Channel 3 button(s) is pressed and
released. The signal will continue until channel three is pressed again.
A l l a a t t c c h h e e d d / / r r e e s s e e t t w w i i t t h h i i g g n n i i t t i i o o n n output works similar to the latched output, but will also reset
(output will stop) when the ignition is turned on and then off.
A 3 3 0 0 s s e e c c o o n n d d t t i i m m e e d d output will send a signal for 30 seconds when channel three is pressed. This
output can be shut off during the 30-second period by pressing Channel 3 again.
This output can also be programmed to provide a s s e e c c o o n n d d u u n n l l o o c c k k p p u u l l s s e e when the unlock button
is pressed a second time after disarming the system. This can be used to unlock the passenger
doors when installing progressive door locks.
IMPORTANT! Never use this wire to drive anything but a relay or a low-current input!
This transistorized output can only supply 200 mA, and connecting directly to a
solenoid, motor, or other high-current device will cause the module to fail.
H1/4 BLACK/WHITE (-) 200 mA domelight supervision output
Connect the H1/4 wire to the optional domelight supervision relay as shown in the following
diagram:
IMPORTANT! This output is only intended to drive a relay. It cannot be connected
directly to the domelight circuit, as the output cannot support the current draw of one
or more bulbs.
6
© 2004
Directed Electronics, Inc.