Directed Electronics 650 ESP Owner's Manual
  1. Manuals
  2. Brands
  3. Directed Electronics Manuals
  4. Car Alarm
  5. 650 ESP
  6. Owner's manual
Directed Electronics 650 ESP Owner's Manual

Directed Electronics 650 ESP Owner's Manual

Directed electronics model 650 esp car alarm owner's guide
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Model 650 ESP
Owner's Guide

Advertisement

Table of Contents
loading

Related Manuals for Directed Electronics 650 ESP

Summary of Contents for Directed Electronics 650 ESP

  • Page 1 Model 650 ESP Owner's Guide...
  • Page 3 Limited Lifetime Consumer Warranty Directed Electronics, Inc. ("DEI ® ") promises to the original purchaser to repair or replace with a comparable reconditioned model any DEI unit (hereafter the "unit"), excluding without limitation the siren, the remote transmitters, the associated sen-...
  • Page 4 Your full name and address Authorized dealer's company name and address Type of alarm installed Year, make, model and color of the automobile Automobile license number Vehicle identification number All security options installed on automobile Installation receipts 1999 Directed Electronics, Inc. ©...

  • Page 5: Table Of Contents

    Security & Convenience Expansions Quick Reference Guide (Removable) 1999 Directed Electronics, Inc. © ....... 30...

  • Page 6: Standard Configuration

    Standard Configuration 1999 Directed Electronics, Inc. ©...

  • Page 7: What Is Included

    What is Included 3-Channel Receiver A pair of two-button transmitters A Stinger ® Doubleguard ® dual-output shock sensor (on-board the control module) 1999 Directed Electronics, Inc. ©...

  • Page 8: System Maintenance

    (2) This device must accept any interfer- ence received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to oper- ate this device. 1999 Directed Electronics, Inc. ©...

  • Page 9: Transmitter Functions

    The auxiliary output controls _____________________________. Buttons An optional auxiliary convenience or expansion function that you have added to your system can be activated by pressing simultaneously. The auxiliary output controls _____________________________. 1999 Directed Electronics, Inc. © for less than one second...

  • Page 10: Expanded Configuration

    If the vehicle’s power door locks have been connected to the sys- tem, the doors will lock. While the system is armed, the status LED will flash approximate- ly once per second, showing that the system is actively protecting 1999 Directed Electronics, Inc. ©...
  • Page 11 Heavy impacts will trigger the system. The triggered sequence is between 1-180 seconds of constant siren and flashing parking lights. 1999 Directed Electronics, Inc. © ® signal. When trig-...

  • Page 12: Multi-Level Security Arming

    Multi-Level Security Arming feature. Each time the arm button is pressed again, a different security level is selected. The different security levels can be selected as follows: Pressing the arm button one time: The siren chirps once. The system is armed. 1999 Directed Electronics, Inc. ©...

  • Page 13: Arming While Driving

    The siren will chirp twice and the LED will stop flashing. NOTE: If programmed for the optional Vehicle Recovery System (VRS) feature, arming with the transmitter will arm the VRS feature. (See VRS section of this guide.) 1999 Directed Electronics, Inc. ©...

  • Page 14: Disarming

    The six second timer is provided for your convenience, in case you accidentally trigger the system. Disarming Without a Transmitter This feature allows you to disarm the system without the transmit- ter should it be lost, damaged or disabled. In order to disarm 1999 Directed Electronics, Inc. ©...

  • Page 15: Silent Mode

    Silent Mode. This ensures that no chirps will be emit- ted by the siren in an area you want chirp-free. The system is still fully capable of triggering. Only the Warn Away 1999 Directed Electronics, Inc. © DRW-35 ™...

  • Page 16: Panic Mode

    10 seconds. The status LED will light solidly if you are entering Valet Mode, and it will go out if you are exiting Valet Mode. ® Mode. This is very useful when DRW-35 1999 Directed Electronics, Inc. ©...

  • Page 17: Remote Valet

    After the third trigger, NPC that sensor or switch (along with any other sensors or switches sharing the same zone) for 60 minutes. 1999 Directed Electronics, Inc. © ® Circuitry (NPC ™...

  • Page 18: Diagnostics

    It detects any faulty switches and sensors and pre- vents them from disabling the entire system. The microprocessor will also record and report any triggers that occurred during your absence. ™ 1999 Directed Electronics, Inc. ©...

  • Page 19: Arming Diagnostics

    Zones section). The system will retain this information in its mem- ory, and continue to chirp four or five times each time it is dis- armed, until the next time the ignition key is turned on. 1999 Directed Electronics, Inc. © ™...

  • Page 20: Table Of Zones

    LED has been reset by turning on the ignition, your dealer can still recall the last two zones that were trig- gered. Contact your dealer for details. DEALER-INSTALLED OPTIONS ® 1999 Directed Electronics, Inc. ©...

  • Page 21: Code-Hopping

    Your system transmits and receives at 434 MHz. This provides a cleaner spectrum with less interference and a more stable signal. Enjoy a phenomenal increase in range – even in areas with high radio interference. 1999 Directed Electronics, Inc. ©...

  • Page 22: Owner Recognition

    Valet Mode. This applies to all states of the system includ- ing arm, disarm, VRS ® , and Valet Mode. ® ® 1999 Directed Electronics, Inc. ©...

  • Page 23: Power Saver Mode

    Valet Mode, the LED will shut off. If the system remains in Valet Mode, the LED will come back on the next time the ignition is turned on and then back off. 1999 Directed Electronics, Inc. ©...

  • Page 24: Programming Options

    (only when arming with the transmitter). Passive locking allows the vehicle's doors to lock when the security system passively arms (after the 30 second countdown). This feature only works if passive arming has been programmed. 1999 Directed Electronics, Inc. ©...
  • Page 25 Valet ® switch the programmed number of times. AED is disabled when the system is in Valet ® Mode. NOTE: This feature will only function if the Failsafe ® Starter Kill relay has been installed. 1999 Directed Electronics, Inc. ©...
  • Page 26 Any of these tones can be eliminated by your dealer, result- ing in a unique, easily identifiable siren sound. The siren chirps can be either full volume or 6 decibels quieter than the full alarm blast. 1999 Directed Electronics, Inc. ©...

  • Page 27: Installation Options

    Please refer to the Vehicle Recovery System section of this manual for a complete explanation of how the Vehicle Recovery System operates. 1999 Directed Electronics, Inc. © ® ): VRS is an anti-carjacking...

  • Page 28: Vehicle Recovery System

    Any installation which allows this product to shut down a vehicle's engine when it is running is contrary to the product’s design and intended usage, and DEI ® hereby expressly disclaims any liability resulting therefrom. 1999 Directed Electronics, Inc. ©...

  • Page 29: Arming The Vrs

    This time could be used to notify authorities that your vehicle has been hijacked, and tell them what the VRS Fifteen seconds after the siren chirps begin, the siren’s output will change to a continuous blast. 1999 Directed Electronics, Inc. © ® before leaving the vehicle. The ®...

  • Page 30: Disarming The Vrs

    If the system has not entered the triggered sequence (siren has not started chirping): 1. Turn the ignition on. 2. Press the disarm button on the transmit- ter for one second. The lights will flash and the siren will chirp twice. ® ® triggering se- 1999 Directed Electronics, Inc. ©...
  • Page 31 VRS. To disarm the VRS during a VRS trigger sequence: 1. Turn the ignition on. 2. Press the Valet grammed number of times to disarm the DRW-35 ® 1999 Directed Electronics, Inc. © ® switch the pre-pro- system.

  • Page 32: Glossary Of Terms

    Siren: Noise generating device usually installed in the engine compartment of the vehicle. It is responsible for generating the "chirps" you hear, as well as the six tones you hear while the alarm is triggered. 1999 Directed Electronics, Inc. ©...
  • Page 33 Zone: A zone is a separate input that the alarm can recognize as unique. Each input to the system is connected to a particular zone. Two or more inputs often share the same zone. 1999 Directed Electronics, Inc. ©...

  • Page 34: Security & Convenience Expansions

    In addition, the 545T will turn your headlights on whenever the windshield wipers are used. A transmitter function can also be used to turn on your parking and headlights for a pro- grammed time. 1999 Directed Electronics, Inc. ©...
  • Page 35 DEI security system. Using the 820T, many of the security and convenience fea- tures of your DEI security system can be operated from any touch tone telephone. 1999 Directed Electronics, Inc. ©...
  • Page 36 Notes 1999 Directed Electronics, Inc. ©...

  • Page 37: Quick Reference Guide (Removable)

    Location of Valet switch__________________________________ Number of Valet switch pulses for disarming_________________ 1999 Directed Electronics, Inc. © of your transmitter . You will hear two chirps, and the park- ®...
  • Page 40 20 patents in the field of advanced electronic technology, DEI is ISO 9001 registered. Quality Directed Electronics products are sold and serviced throughout North America and around the world. Call (800) 274-0200 for more information about our products and services.

Table of Contents