Connecting The Power Cord - Pioneer AVH-100DVD Owner's Manual

Section
21 Connection

Connecting the power cord

Yellow
Connect to the constant 12 V supply terminal.
Orange/white
Connect to lighting switch terminal.
Red
Connect to terminal controlled by ignition switch (12 V DC).
Black (chassis ground)
Connect to a clean, paint-free metal location.
Front speaker
Left
Rear speaker or
Subwoofer (4 Ω)
When using a subwoofer of 70 W (2 Ω), be sure to connect with Violet and Violet/black leads of this
unit. Do not connect anything to Green and Green/black leads.
Not used.
36
En
Wired remote input
This product
USB/iPod input
AUX jack (3.5 ø)
Antenna input
Microphone input (Function of AVH-200BT)
Fuse (10 A)
White Gray
Front speaker
White/black Gray/black Right
Green Violet
Rear speaker or
Subwoofer (4 Ω)
Green/black Violet/black
Green Violet
Subwoofer (4 Ω)
× 2
Green/black Violet/black
Connection
Hard-wired remote control adapter can be connected (sold separately).
Use a mini plug cable to connect with auxiliary device.
USB cable (Supplied with this unit) Connect to separately sold USB device.
4 m (13 ft. 1 in.)
Violet/white
Of the two lead wires connected to the back lamp, connect the one in which the voltage changes
when the gear shift is in the REVERSE (R) position. This connection enables the unit to
sense whether the car is moving forwards or backwards.
Light green
Used to detect the ON/OFF status of the parking
brake. This lead must be connected to the power
supply side of the parking brake switch.
Blue/white
Connect to system control terminal of the power amp or
auto-antenna relay control terminal (max. 300 mA 12 V DC).
With a 2 speaker system, do not connect anything to the speaker leads
that are not connected to speakers.
Microphone (Function of AVH-200BT)
Parking brake
switch
Power supply side
Ground side
Note:
· Change the initial setting of this unit.
The subwoofer output of this unit is
monaural.