Functions - Dynacord AXM 12A User Manual

14 en | Configuration
6.2.3

Functions

This section describes the functions (factory presets) of the AXM 12A that you can select in
the menu.
Preset
number
F1
F2
F3
F4
F5
F6
18-Mar-14 | 02 | F01U290507
Name Description
Monitor 1 Intended for use as a floor monitor with a flat frequency response.
Monitor 2 Intended for use as a floor monitor in a very noisy environment.
Certain frequencies are enhanced to help the vocals or other lead
instruments to cut through the mix.
Monitor 3 Intended for use in a dual/twin setup. If you use two AXM 12A in
front of you, acoustical coupling effects lead to a nonlinear
frequency response. These coupling effects are compensated by
this preset.
GuitarCab Intended for use as a guitar monitor. With a built in speaker
simulation which emulates a 4 x 12-inch cabinet, you can connect
your guitar amp/multi effects processor directly to the AXM 12A.
MAIN PA Select this function if the AXM 12A is used as a full-range PA
speaker.
TOP + SUB Activates a high-pass filter when the AXM 12A is used as PA
speaker together with a powered subwoofer.
User manual
AXM 12A
Bosch Sicherheitssysteme GmbH