Additional Battery Pack (6 Cell And 9 Cell); Additional Ac Adaptor; Usb Fdd Kit; External Monitor - Toshiba L3 User Manual

Additional battery pack (6 Cell and 9 Cell)

You can increase the portability of the computer with additional battery
packs (6 Cell: PA3536U-1BRS/PA3536U-1BAS, 9 Cell: PA3537U-1BRS/
PA3537U-1BAS). If you're away from an AC power source, you can replace
a low battery with a fully charged one. See Chapter 6,
Modes.

Additional AC adaptor

If you frequently transport the computer between different sites such as
your home and office, purchasing an AC adaptor for each location will
reduce the weight and bulk of your carrying load. (2 Pin: PA3468U-1ACA,
3 Pin: PA3468E-1AC3)

USB FDD Kit

The 3 1/2" external FDD drive module can be connected to the USB port.

External monitor

An external analog monitor can be connected to the external monitor port
on the computer, Port Replicator. The computer supports VGA and Super
VGA video modes. To connect a monitor, follow the steps below.
If an external monitor is connected to the computer, do not connect the
Port Replicator. First disconnect the external monitor from the computer
then connect the Port Replicator and use its external monitor port.
The hibernation and sleep feature can be used with an external monitor.
Simply enable Resume and the computer will maintain the data as it is
displayed on the external monitor.
1. Connect the monitor to the external monitor port.
2. Turn the monitor's power on.
When you turn on the power, the computer automatically recognizes the
monitor and determines whether it is color or monochrome.
You can use the HW Setup to select between Auto-Selected and
LCD+Analog RGB displays. Refer to Chapter 7,
If you have selected LCD+Analog RGB under the Display options of the HW
Setup, both the external monitor and the internal LCD will be active when
you turn on the computer. If Auto-Selected is selected, only the external
monitor will be active.
To change the display settings, press FN + F5. If you disconnect the
monitor before you turn the computer off, be sure to press FN + F5 to
switch to the internal display. Refer to Chapter 5,
on using hot keys to change the display setting.
User's Manual
Power and Power-up
HW Setup and Passwords.
The Keyboard, for details
L350/L350D
8-9