LevelOne WUA-0615 User Manual page 27

Note
If WPS fails, click the PBC button few more times to try again.
4. When an access point or a WPS enrollee is connected, you can click Disconnect to disconnect
from the connected device, or select another WPS-enabled wireless access point or enrollee,
and then click Connect to establish connection.
5. You can also click the "Rotate" button to select the next access point or enrollee in the list and
establish a connection.
6. To delete an access point from the list, click Delete.
WPS Setup - PIN Configuration
The WPS PIN (Personal Identification Number) setup is optional to the WPS button setup. It is more
secure than using the WPS button. All WPS-compatible devices have their own PIN number.
1. When the Wireless USB Adapter is set as an enrollee, the PIN number of your Wireless USB
Adapter is an eight-digit number located at the upper-right position of configuration utility.
Remember this number and input it to your wireless access point as the WPS PIN code.
Please also refer to the user manual of your wireless access point for instructions about WPS
setup.
2. Click PIN button and wait for few seconds to one minute. If a wireless access point with correct
PIN code is found, you will be connected to that access point.
Note
You may have to click PIN for few more times to try again. If you still cannot
connect to an access point this way, please make sure the PIN code you
provided to access point is correct.
3. When the Wireless USB Adapter is set as a registrar, input the enrollee„s PIN number to the
Pin Code box located in the upper-right position of configuration utility.
4. Click PIN button and wait for few seconds to one minute. If a WPS enrollee with correct PIN
code is found, it will be connected to the Wireless USB Adapter.
27