Troubleshooting The Remote Supervisor Adapter - IBM TotalStorage 201 User Reference Manual

5. When you are finished viewing this information, press Esc to return to the main

Troubleshooting the Remote Supervisor Adapter

1. Insert the Remote Supervisor Adapter Support CD into the CD-ROM drive and
2. After the engine boots, the main option menu appears. The main menu contains
3. Use the up and down arrow keys to select Hardware Status and Information
4. Use the up and down arrow keys to select the device you want to look at in
option menu. Remove the CD then restart the NAS 200 engine.
restart the engine. If the engine does not boot from the CD-ROM, use
POST/BIOS setup to configure the CD-ROM drive as a boot device.
the following selections:
v
v
v
and press Enter. The Hardware Status and Information menu contains the list
of devices with the following diagnostic test results:
more detail. Press Enter. You will see a list of tests and results on the device:
Chapter 7. Troubleshooting
75