Tools Needed; Features - Ryobi CMS812 Owner's Operating Manual

Your Compound Mitre Saw has been shipped completely
assembled except for the blade.
WARNING: If any parts are missing, do not
operate this tool until the missing parts are
replaced. Failure to do so could result in
serious personal injury
• Remove all loose parts from the carton. Separate and check
with the list of loose parts. See figure 1.
• Remove the packing materials from around your saw.
• Carefully lift saw from the carton and place it on a level
work surface. Although small, this saw is heavy. To avoid
back injury, get help when needed.
• Do not discard the packaging materials until you have
The following tools (not included) are needed for checking adjustments of your saw and for installing the blade.
■ KNOW YOUR COMPOUND MITRE SAW
Before attempting to use your saw, familiarise yourself with all
the operating features (Fig 2, 2a & 2b) and safety
requirements.
WARNING: Do not allow familiarity with
your saw to make you careless. Remember
that a careless fraction of a second is
sufficient to inflict severe injury.
UNPACKING
carefully inspected the saw, identified all loose parts and
satisfactorily operated your new saw.
• Your saw has been shipped with the saw arm locked in the
down position. To release saw arm, pull out the lock down
pin.
• Lift the saw arm by the handle. Hand pressure should
remain on the saw arm to prevent sudden rise upon release
of the lock down pin.
• Examine all parts to make sure no breakage or damage has
occurred during shipping.
If any parts are damaged or missing, do not attempt to plug in
the power cord and turn the switch on until the damaged or
missing parts are obtained and are installed correctly.

TOOLS NEEDED

FEATURES

■ 1200 WATT MOTOR
Your CMS812 Compound Mitre Saw has a powerful 1200 watt
motor with sufficient power to handle tough cutting jobs. It is
made with all ball bearings, and has externally accessible
brushes for ease of servicing.
■ 210mm BLADE
A 210mm saw blade is included with your compound mitre
saw. It will cut materials up to 55mm thick or 120mm wide,
depending upon the thickness of the material and the setting
at which the cut is being made.
Page 3
Fig.1