White Balance; Tilt Invert - American DJ Vortex 1200 User Instructions

Vortex 1200
will automatically go into stand by mode.
• Hold - If the DMX signal is lost the fixture will stay in the last
DMX set up. If power is applied and this mode is set, the unit will
automatically go into the last DMX set up.
• Show - If the DMX signal is lost or power is applied, the unit will
automatically go into Show mode.
3. Press ENTER to confirm your desired set up.
Sound State
- In this mode the unit will run in sound
active mode.
1. Press the MENU button until "Sound State" is displayed, press
ENTER.
2. Either "On" or "Off" will now be displayed. Use the UP or
DOWN buttons to toggle between "On" and "Off".
3. Press ENTER to confirm your selection, the press and hold the
MENU button to activate.
Sound Sense
- This function will let you adjust the
sound sensitivity of the sound active mode.
1. Press the MENU button until "Sound Sense" is displayed,
press ENTER.
2. Press the UP or DOWN buttons to adjust the sensitivity level.
The sensitivity level can be adjusted between 0 (least sensitive)
and 100 (most sensitive).
3. Press ENTER to set you desired level.
Pan Invert
- Pan Inversion
1. Press the MENU button until "Pan Invert" is displayed, press
ENTER. Either "Yes" or "No" will be displayed.
2. To activate the Pan inversion press the UP or DOWN buttons
until "Yes" is displayed, press ENTER to confim. To deactivate
ADJ Products, LLC - www.adj.com - Vortex 1200 User Manual Page 12
System Menu Vortex 1200
Pan inversion, select "No" and press Enter.

Tilt Invert

1. Press the MENU button until "Tilt Invert" is displayed, press
ENTER. Either "Yes" or "No" will be displayed.
2. To activate the Tilt inversion press the UP or DOWN buttons
until "Yes" is displayed, press ENTER to confim. To deactivate
Tilt inversion, select "No" and press Enter.
Back Light
backlight automatically turn off after two minutes.
1. Press the MENU button until "Back Light" is displayed, press
ENTER.
2. Either "On" or "Off" will now be displayed. Press the UP or
DOWN buttons to select "On" to keep the backlight on at all
times, or "Off" to allow the backlight to turn off after 2 minutes.
Press any button to turn the backlight on again.
3. Press ENTER to confirm.

White Balance

RGB colors to make your desired color.
1. Press the MENU button until "White Balance" is displayed,
press ENTER.
2. Use the UP or DOWN buttons to find the color you wish to
adjust.
3. Once you find the color you want to adjust press ENTER, and
the displayed value will begin to flash. Use the UP or DOWN
buttons to adjust the value. Once you have made your adjust-
ment press ENTER.
4. Repeat steps 2-3 until satisfied.
- Tilt Inversion
- With this function you can make the LCD
- With this function you can adjust the
ADJ Products, LLC - www.adj.com - Vortex 1200 User Manual Page 13
System Menu