Cobra microTALK CXT595 Owner's Manual page 8

Mode Functions
Operation
10 Memory Locations
Your microTALK radio has 10 Memory Locations for storing
your most frequently used channels and channel/privacy code
combinations. These Memory Locations can be selected individually or
can be scanned. (See page 18 for memory location scan.)
To program a memory location:
MEM/ESC Button
1. Press the MEM/ESC button. Memory icon and
the Memory Location show on the display.
HI / LO
2. Press the Channel Up or Channel Down button
to select the memory location (0 through 9).
Channel Button
HI / LO
If a location has been programmed before,
its associated channel/privacy code will be
shown on the display.
3. Press the MEM/ESC button to enter a
new memory location or edit an already
MEM/ESC Button
programmed memory location.
4. Press the Channel Up or Channel Down button
HI / LO
to select the memory location.
5. Press the MEM/ESC button. The channel
Channel Button
HI / LO
numbers will flash on the display.
6. Press the Channel Up or Channel Down button
to select a channel (1 through 22).
7. Press the MEM/ESC button. The CTCSS icon
Memory Channel
and privacy code numbers will flash on the
display.
8. Choose one of the following:
a. Press the Channel Up or Channel Down
Channel Button
button to select a CTCSS privacy code (01
HI / LO
through 38) for the channel.
b. Press the MEM/ESC button to switch from
CTCSS to DCS. The DCS icon and privacy code
numbers will flash on the display. The Channel
Up or Channel Down button can then be used
to select a DCS privacy code (01 through 83)
for the channel.
10
Introduction
If "oF" flashes in place of the privacy code numbers,
•
a privacy code is already set in the opposite (CTCSS
or DCS) system. Press the Channel Up or Channel Down
button to cancel the opposite code and select a privacy
code from the active system for the selected channel.
9. Choose one of the following:
a. Press the MEM/ESC button to enter the channel/privacy code
in the selected memory location. Radio then proceeds to next
memory location, which will blink.
b. Press and hold the MEM/ESC button to save the current state of
the Set Memory Function and return to Standby mode.
MEM/ESC Button
HI / LO
Memory Channel
Channel Button
HI / LO
Operation
Customer Assistance Warranty
To recall a stored memory channel location:
1. Press the MEM/ESC button until the Memory
icon and the memory location number flash on
the display.
2. Press the Channel Up or Channel Down button
to select a memory location (0 through 9).
If a location has been programmed before,
its associated channel/privacy code will be
shown on the display.
3. Press and hold the MEM/ESC button to return
to Standby mode on the selected memory
location.
A memory location can be reprogrammed
at any time it is displayed. Press the
MEM/ESC button to begin.
Nothing Comes Close to a Cobra
11
®