System expansions
System expansions
Servicing
Components
System expansion
Device,
Upgrades,
Repairs to the device must only be performed by qualified technicians. Incorrect repairs
may greatly endanger the user (electric shock, fire risk) and will invalidate your warranty.
After consulting the Hotline/Help Desk, you may remove and install the components
described in this manual yourself.
As the device has to be shut down in order to install/deinstall system hardware
components, it is a good idea to print out the relevant sections of this chapter beforehand.
The following illustrations may differ slightly from your device, depending on its configuration level.
If further documentation was delivered with your device, please also read this through carefully.
In addition, before removing or installing system components, please pay attention to the following:
The device must be switched off when installing/removing the system
expansions and may not be in energy-saving mode.
Remove the power plug before opening the device.
Be careful that no wires become trapped when removing or installing components.
When installing components that become very hot, make sure that the maximum
permissible temperature of the components in operation is not exceeded.
An update of the BIOS may be required for a system expansion or hardware
upgrade. Further information can be found in the BIOS help section or if
necessary in the Technical Manual for the mainboard.
Overview of optional system components
The following optional system components can be installed in the various device types:
System component
Hard disk
SmartCard reader
Speaker
Power over Ethernet
module
Third serial port
Parallel port
PCIe dual serial card
PCIe ATI V3900
28
FUJITSU Thin Client
FUTRO S720
—
optional
optional
optional
—
—
—
—
FUJITSU Thin Client
FUTRO S920
—
optional
optional
optional
optional*
optional*
optional*
optional*
FUJITSU Desktop
ESPRIMO A525-L
Installed when
delivered
—
optional
optional
—
—
—
—
Fujitsu