Table of Contents
Advertisement
3
Cam the module home by manually closing the PSU handle (Figure 2–4). You should hear a
click as the handle latches engage.
4
Connect the power supply cord to the power source and switch the power supply ON.
Figure 2–2
Figure 2–3
IBM System Storage DCS9550 1S1 Storage Expansion Unit Installation, Service, and User Guide
Important
Install the Power Supply/Cooling module (PSU 0) in the bay on the right
side (Rear Bay 1) of the enclosure in an "upside down" orientation. If
necessary, reorient the power cord clip so that the power cord can be
properly retained.
AC Power Supply/Cooling Module - Handle in Open Position
Installing an AC Power Supply Cooling Module (1)
Installation
19
Advertisement
Table of Contents
