Product Views; Front View; Interface View; Hardware Installation - IP-Cam JW0004 User Manual

1.4. Product Views

1.4.1 Front View

1.4.2 Interface View

Figure 1.1 Figure 1.2
1: Audio Out , 2: Audio In
3: Ethernet interface: RJ-45 interface. Power Supply Light: constant on after power up
Network light: constant sparkle after power up data transmission.
4: Antenna:
5: Power input interface: connect direct current 5V Power
6: TF Socket : Useless for JW0004.

1.5 Hardware Installation

Follow the steps below to set up your camera hardware. Make sure to follow each step
carefully to ensure that the camera operates properly
1. Install the Wi-Fi antenna (For wireless model) .
2. Plug the power adaptor into camera
3. Plug the network cable into camera, the other side to the router/switch
4. It takes approx 30 seconds to boot up the camera, then you will find the IP address from
"Search Tool" (Figure: 1.8)
5. When the power on and network cable connected, the green led of the real panel will keep
on, The yellow led will keep flash.
Figure 1.3
5