Battery Installation/Battery Charging; Registering Handset To Base Unit - Panasonic KX-TGA680 Installation Manual

Battery installation/Battery charging
Important:
Installation
• Use the supplied rechargeable batteries. For replacement, we recommend using
the Panasonic rechargeable batteries noted on page 2.
• Wipe the battery ends(~,
8>
with a dry cloth.
• Avoid touching the battery ends(~,
8>
or the unit contacts.
• Confirm correct polarities (~,
8).
• USE ONLY Ni-MH batteries AAA (R03) size.
• Do NOT use Alkaline/Manganese/Ni-Cd batteries.
Charge for about 7 hours.
• When the batteries are fully charged, "Fully
charged"
is displayed.
Note:
Rechargeable
Ni-MH ONLY
~
Q
"Charqinq"
is displayed.
• If the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends(~,
8>
and the charge contacts with a dry cloth and
charge again.
Registering a handset to a base unit
1
Base unit:
Press and hold [LOCATOR] for about 5 seconds.
• Depending on the base unit, a registration tone sounds.
• If all registered handsets start ringing, press [LOCATOR] again to stop,
then repeat this step.
2
Handset:
Place the handset on the base unit or charger, then wait until a long beep
sounds and Tis displayed.
Note:
• If an error tone sounds, or if
Y
is displayed, register the handset according to
the base unit's operating instructions.
For assistance, please visit http://www.panasonic.com/help
3